USE
CAUTION
Before starting the vacuum cleaner, remove any large objects that could block the tube or the nozzle. Turn off
the appliance immediately if the tube or the nozzle becomes blocked.
Do not completely pull out the cord. It should not be pulled out further than the red mark. The yellow mark indicates
the optimal cord length.
Turn on the vacuum cleaner only when you have checked that all parts have been properly attached
and that the dust container and the filters have been correctly inserted and are completely dry.
The handle has an air valve with which you can quickly reduce the suction force if necessary. Open the valve when
cleaning curtains, rugs or other light mobile items. Otherwise you should keep this valve closed.
1
Assemble the appliance as described in the "Assembling the Appliance" section.
The cord is located on the back of the vacuum cleaner and below the automatic cord winder.
2
Pull the cord out to the desired length but not further than the red mark.
3
Insert the plug in a properly installed outlet that is easily accessible.
4
Press the On/Off button to turn the appliance on.
5
To turn it off, press the On/Off button again.
Guide the nozzle over the surface to be cleaned. The vacuum cleaner can be pulled along
6
after you like a sled.
After you have finished vacuuming, turn off the appliance and remove the plug
7
from the outlet.
8
Firmly hold the cord and press the automatic cord winder. The cord will roll back in.
Empty the dust container regularly (see "Cleaning the Appliance"). Store the appliance
9
in a secure place (see "Storage").
7