Operation - Hitching And Unhitching - EGO PECM01 Guide D'installation

Operation - Getting Started (cont.)
The Mover moves at one speed after the intitial 'soft-start'. The speed can increase a little when going downhill and
decrease a little when going uphill. TIP: The mover is more efficient when reversing the caravan up an incline.
After manoeuvring, deactivate the Ego mover by double-clicking the power button on the remote control again. The LED
on the remote control will turn off.
Apply the handbrake first and then disengage the drive rollers from the tyres.
Turn off the Battery Power Isolation Switch.
Store remote control in a safe place (out of reach of children or other unauthorised people).

Operation - Hitching and Unhitching

It is possible to position the caravan's hitch exactly over a stationery car's tow ball using the Mover. But please
be very careful!
Use the button controls on the remote control to bring the caravan to the car. It is better to reach the tow ball with
several short "trips" rather than trying to do it in one "trip". When the hitch is right above the tow ball of the vehicle,
lower the hitch to the ball and engage in the normal way using the jockey wheel.
Hitch the caravan in the normal way ready for towing.
Release the rollers from the caravan's tyres. You cannot tow the caravan with the Mover
engaged! Make sure that the rollers are fully disengaged!
Trying to drive away with the Mover still engaged, will damage the mover, your caravan tyres and strain your tow
vehicle!
Maintenance
To prevent the battery from becoming totally discharged during long periods of inactivity it must be disconnected and
recharged before using again.
Please check regularly that the rollers of the drive units are free of any dirt, or debris that may have been picked up from
the road. Any further maintenance is not required.
Please check regularly the distance between the rollers and the tyres. In the neutral (fully disengaged) position this must
be 20 mm.
Once a year have your Ego caravan mover maintained and visually inspected. This inspection must include all the bolt/
nut connections, the cables and electrical connections and lubrication of movable parts/joints.
In case of any failures or problems, please contact your Ego Mover supplier.
Trouble Shooting
Should your mover fail to operate, please check the following:
Unit fails to operate, does not function at all:
Make sure that the Battery Power Isolation Switch (29) is turned on.
Is the Remote Control Handset 'paired' with the Control Unit? To 'pair' the Handset and Control Unit please follow the
procedure detailed in the section 'Operation - Electronic Control Unit' regarding the Reset Button (Fig.3a).
Check the batteries of the remote control. If empty, renew using three new 'AAA' 1.5V batteries.
Caravan battery could be empty. Check electronics box (Blue LED is on and Red LED is flashing twice slowly). If empty,
recharge completely or renew caravan battery before taking any further action.
Ref: PECM01-UM-0110-Rev.A.
Ego Page UK-8