ubbink Robotclean 3 PLUS Mode D'emploi page 4

1 Robotclean 3 PLUS Operating Manual and Parts List
Cleaning process
General advice
- The robot must be used in clean water.
- The pH-value of the pool water should be between 7.0 and 7.4.
- When commissioning the pool after winter storage, the floor must be cleaned for the first time with a landing net or vacuum cleaner before the robot is used.
The pool cleaner works according to the chaotic cleaning principle, which means that it automatically changes direction as soon as it touches the pool wall (or rises up and down for
pools with a curved bottom). As soon as the pool cleaner reaches the water line it cleans it.
Depending on the situation, the cleaner can clean the same area for up to one minute. After this time, it continues to clean automatically and therefore cleans the entire pool
automatically.
After the work cycle is complete, turn the cleaner off and gently pull the rope parallel towards the pool wall. Use the handle (not the cable!!) to lift the device out of the water. Hold the
cleaner above the water for 10-15 seconds to allow the water to drain from the device.
Cleaning the water line
The following steps are not required if the cleaner climbs the pool cleaner walls easily.
However, if it is difficult for the pool cleaner to climb the pool walls and clean the waterline, please use the two foam blocks (or four if required) included in the delivery, which give the
pool cleaner an additional buoyancy when climbing the pool walls.
• Open the two filter covers
• Remove the adhesive protection films and stick one foam block on both inner sides of the cover
• If the buoyancy is not yet sufficient, use the two additional foam blocks
Note: Periods out of use
1. You can also stick both foam blocks on top of each cover without opening the cover.
The pool cleaner must be dried sufficiently after finishing cleaning. Whenever the pool cleaner is not in
2. Press the foam blocks down well onto the covers. Please wait 24 hours before using the cleaner again.
use, it should be stored in a shady and well ventilated place. Frost and direct sunlight should be
avoided.
Periods out of use
The pool cleaner must be dried sufficiently after finishing cleaning. Whenever the pool cleaner is not in use, it should be stored in a shady and well ventilated place. Frost and direct Maintenance and care
sunlight should be avoided.
Cleaning the filter
Press the button on the side to open the respective filter flap and remove the corresponding filter.
Maintenance and care
Clean the filters with a garden hose and then insert the filters into the pool cleaner in reverse order.
Cleaning the filter
Clean the filter inserts after each use of the pool cleaner.
Press the button on the side to open the respective filter flap and remove the corresponding filter. Clean the filters with a garden hose and then insert the filters into the pool cleaner
Cleaning the housing
in reverse order.
Only use water and a soft cloth. Be careful not to apply too much pressure to the housing, otherwise it
Clean the filter inserts after each use of the pool cleaner.
may be destroyed. Do not use a coarse sponge or detergent.
Cleaning the housing
Only use water and a soft cloth. Be careful not to apply too much pressure to the housing, otherwise it may be destroyed. Do not use a coarse sponge or detergent.
Repairs
Repairs
If the housing or transformer are damaged, a repair is not possible. You may not continue using the affected part and dispose of the pool cleaner or transformer.Ordering spare parts
If the housing or transformer are damaged, a repair is not possible. You may not continue using the
affected part and dispose of the pool cleaner or transformer.
Ordering spare parts
When ordering spare parts, or in the course of troubleshooting according to the item "Troubleshooting", we require the following information:
1. Article name
2. Article number of device
3. Copy of the invoice
Ordering spare parts
4. Error description
When ordering spare parts, or in the course of troubleshooting according to the item