ADEO Services ZSPW400-D Mode D'emploi page 5


Tighten the hose with a hose clamp.
3. Connection for hose of Ø 32 mm:

Cut off top two nipples on the universal fitting at the position

Screw and push a hose of Ø 32 mm onto the universal fitting.

Tighten the hose with a hose clamp.
Note: hose, tap adaptor, hose quick connector and hose clamp are not provided.
CHECK BEFORE OPERATION
- Look to see if there is any damage to the pump (especially to the power
cable and plug).
- The height of the point of switching "on" and "off" should be easy to achieve
- Check the operation in a barrel filled with water. Immerse the pump into
water and then slightly lift and put down the float switch. The pump starts and
stops.
- The float switch should not touch the bottom before the pump cut off, or
there will be a risk of running empty.
OPERATION
The float switch turns the pump on automatically when the water level exceeds the cut-in
height and the water is pumped out.
The float switch turns the pump off again as soon as the water level falls below the cut-
out height.
1. Stand the pump on a firm surface or use a rope attached through the handle.
Ensure that the float switch can move freely.
2. Plug the power cable into a mains socket.
3. Push the cable of the float switch into the float switch lock
Warning: In order to protect the pump from running empty, please always keep the
pump upright and the float switch is not jammed in mud or obstructed by other objects.
CARE AND MAINTENANCE
Unplug the power cord from the pump before any
maintenance and cleaning.
Use a soft, damp cloth to clean the plastic part. Do not use detergents, solvents or sharp
objects.
Do not select a cable length that is too long or short to
ensure that the float switch can turn on and off properly.
The cable length between the float switch and the float
switch lock must always be at least 10 cm.
The shorter the length of cable between the float switch
and the float switch lock, the lower the cut-in height and the
higher the cut-out height.
Starting and stopping of the pump depends on the water
level for which the float switch floats.
EN
○
b .