ADEO Services ZSPW400-D Mode D'emploi page 4

15. Never use the pump where there are people in the
water.
16. This appliance should not be used for drinking water.
17. Pollution of the liquid could occur due to leakage
of lubricants
INSTALLATION
This pump is scheduled for installation in domestic use only:
- In places where there is a risk of flooding
In sumps.
-
Obey free space around the pump for the float switch can operate without risk of being
blocked (eg use a sump of 40 x 40 x 50cm minimum).
for operation in liquid not exceeding 35 ° C.
Before usage, make sure that the water evacuated could be conducted without risks
(refer to local regulations). Do not place the evacuation of water on a highway or other
passageway.
HOSE CONNECTION
The pump is equipped with a universal fitting which allows connecting hoses of various
sizes as listed below:
1. Connection for hoses of Ø 13 mm / 15 mm / 19 mm:

Cut off the topmost nipple on the universal fitting at the position

Screw a 25.4 mm tap adaptor onto the universal fitting.

Connect a hose quick connector (for hose of Ø 13 mm or 15 mm or 19
mm) to the tap adaptor, then insert the hose and tighten it.
2. Connection for hose of Ø 25 mm:

Screw and push a hose of Ø 25 mm onto the universal fitting without
cutting anything.
The pump is scheduled
EN
○
a