Toolland DT 20008 Mode D'emploi page 14

DT 20008
Keep the trigger clean and free from

sediment and chemicals by regularly
flushing through after use.
If necessary remove and clean the shuttle

in the trigger.
Outlet and dip tube
To rewash the outlet or replace the dip

tube, unscrew the hose nut and pull the
outlet spigot and dip tube through the
outlet body.
Winter use
Drain liquid from all parts after use to

prevent damage from freezing.
Annual Maintenance
At least once a year thoroughly clean the

whole sprayer and apply silicone grease
to all moving parts.
Test with water and if any washer or seal

has perished it must be replaced.
FAULT FINDING CHART
Fault May be due
to
Weak or no 1.insufficient
spray pressure or
loss air.
2.obstruction
Distorted Partial
spray blockage in
spindle or
nozzle
Leaks 1.build up of
sediment or
foreign matter
on internal
sealing
surfaces.
Unit will not Swelling of
function sealing rings
or total
blockage
Handle rises Faulty non-
return valve
www.toolland.eu
Remedy
1.if insufficient
pressure check
maintenance
2.if obstruction
check
maintenance
Check
maintenance
1.check
maintenance
and if
necessary
replace sealing
rings.
2.replace
sealing rings
Check the
maintenance
Check the
maintenance
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your sprayer need replacement after
exceeded use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
English
14