Ground Zero Mobile Entertainment PLUTONIUM GZPA 1.8000SPL-HC Mode D'emploi page 8

Tools and materials you need
Screwdriver
•
Electric drill 1/8 carbide drill bit
•
Mounting screws
•
Use min 50 mm² power wire
•
Use min 50 mm² ground wire
•
Use min 6 mm² speaker wire
•
Caution!
As a precaution it is advisable to disconnect the vehicle's battery before making connection to the
•
+12 Volts supply wiring (see owner's manual of your car for further information!).
Please use great caution drilling your trunk, your gas tank and brake lines can be damaged by
•
puncturing with your drill bit – this could cause damage or failure of your cars operating systems.
Take care of square edges, the cable could be rub through.
•
WARNING
High powered audio systems in a vehicle are capable of generating „Live Concert" high level of
sound pressure. Continued exposure to excessively high volume sound levels may cause hearing
loss or damage. Also, operation of a motor vehicle while listening to audio equipment at high
volume levels may impair your ability to hear external sound such as; horns, warning signals, or
emergency vehicles, thus constituting to a potential traffic hazard. For safety reasons we
recommends listening at lower volume levels while driving.
Planning your system
Before installation, consider the following notes:
a) Select a suitable location that is convenient for mounting, is accessible for wiring and has enough
room for air circulation and cooling.
b) If your radio is equipped with preamplifier outputs (RCA), it is advisable to use them.
c) Please consider the enormous power consumption (up to 600A) of this amp when designing the
setup. We strongly recommend to install an additional battery. Too little power from the battery /
alternator may cause defects on your amplifier and your car.
All manuals and user guides at all-guides.com
Mounting your amplifier
RCA Connections – Single mode
Single amp input connection
Select a suitable location that is convenient for mounting, is accessible for wiring and has ample
•
room for air circulation and cooling.
Use the amplifier as a template to mark the mounting holes, remote the amplifier and drill 6 holes
•
(use extreme caution, inspect underneath surface before drilling!). Secure the amplifier with the
mounting screws.