Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RZ_AUTOPUMP_Li-on__DE/GB/FR/NL/IT/DK_979489-00.qxp_Text_GB 10.02.21 16:49 Seite 27
NOTE!
When the previously set maximum operat-
ing pressure is reached, the integrated
pressure switch switches off the pump. The
spraying process can now be started. If the
tank pressure has dropped between 0.3-0.5
bar or 4.35-7.25 psi, the pump switches on
again automatically and increases the
pressure until the set maximum operating
pressure is reached again. You can con-
tinue to work with the sprayer.
The running time of the pump depends
heavily on how much spray is left in the
container. As the tank content decreases, it
extends the running time of the pump in
order to reach the maximum set operating
pressure again. If the BATTERY COM-
PRESSOR does not switch off after 15 min-
utes of continuous operation, there is a leak
in the sprayer or in the BATTERY COM-
PRESSOR. In this case, switch off the BAT-
TERY COMPRESSOR and check the sprayer
or BATTERY COMPRESSORR for leaks.
If the device is not used for more than
15 minutes after being switched on, it
switches off automatically. To start work
again, switch the On-/Off-rocker switch (A)
off/on once. Now start the BATTERY COM-
PRESSOR again with the (F) button.
7.1.1 Battery status indicator
14
Figure
14
After switching on the device with the
On-/Off-rocker switch (A), the charge
status of the battery is shown in % in the
display for 5 seconds. The charge status
can then be read from the battery sym-
bol (G) in the top left of the display.
Battery power (battery symbol):
0%
≤ 30%
NOTE!
In rare cases, after the battery has been
removed and then reinserted, the battery
status indicator (G) can display a higher
battery power than before battery removal.
The reason is that the last battery power
during operation is saved in the device.
≤ 60%
100%
27
Once the battery has been removed and
reinserted into the device, the battery
power is remeasured and a higher power
can therefore be displayed on the indicator.
7.1.2 Battery operating time
The service life of the battery mainly dep-
ends on the load applied to the device.
Work in max. pressure range as well as
with a low filling quantity in the container
leads to a shorter battery operating time.
Handle battery and device as described in
the instructions.
7.2 Function
15
Figure
NOTE!
When spraying, please observe the instruc-
tions in the user manual for the spray
device and the information provided by
the agent manufacturer. Operate your cor-
responding GLORIA pressure sprayer (3-/5-
/8-liter) with a max. operating pressure of
2,5 bar, for working with the BATTERY-
COMPRESSOR.
8
Decommissioning & Storage
8.1 Decommissioning
16
18
Figures
–
16
Take the device out of operation by
switching the On-/Off-rocker switch
(A) to "0" and thereby switch the
device off completely.
ATTENTION
Improper use of the device poses a risk
of damage to property! You should
therefore observe the following safety
instruction:
To
prevent
battery
remove battery from device when
not in use for a prolonged time. For
this purpose, remove battery from
adapter. Proceed as follows:
17
1. Dry the surfaces on the
battery holder all around with
a dry and clean cloth.
18
2. Now remove the battery and
dry the contact surfaces of the
battery and the device again.
discharge,
Publicité
Chapitres
Table des Matières
