Troubleshooting; Restoring Factory Default Settings - Esoteric G-02X Mode D'emploi

Troubleshooting

If you experience a problem with this unit, please take a moment to
review the following information before requesting service.
If this product still does not operate correctly, contact the retailer
where you purchased it.
The unit does not turn on.
e Check that the power cord is plugged into a working power
outlet.
e Check that the power cord is properly connected to this unit.
The clock output is not synchronizing another device.
e Confirm that the clock being output is supported by the
device connected to this unit. (Select a clock frequency that
the connected device can use.)
The input and synchronization of clock signals might vary
according to the device. Refer to the owner's manual of each
device for how to connect and set them.
The desired frequency cannot be selected by pressing the A
and B buttons.
e Set the reference frequency with the frequency mode setting
(FREQ) first, and then use the A and B buttons (page 15).
18

Restoring factory default settings

Settings are retained even if the power plug is disconnected.
Follow these procedures to restore all settings to their factory
defaults and clear the unit's memory.
1
Turn the unit off.
If the unit is on, press the POWER button to turn it off and wait
for more than 30 seconds.
2
Press the POWER button while holding down
the MENU button.
o Release the MENU button when the unit turns on and the
display lights.