Hayward Pool Products ColorLogic 80 Manuel Du Propriétaire page 10

Wiring Multiple Drivers
Driver 2
To additional Drivers
Driver 1
To ColorLogic 80
Accent Lights (5)
To ColorLogic 80
Accent Lights (5)
Operation
ColorLogic 80 lights can be used in Universal ColorLogic mode or Omni Direct mode. For Omni Direct
mode, the lights must be built after June 2018 and used with a Hayward Omni controller (page 10).
Operating the 1/2" LED Lights
The light is controlled through power-cycling: a method of changing light programs which requires
no special interface. To activate the light, simply turn on the switch powering the transformer. To de-
activate the light, turn off the switch. To advance to the next light program (fixed color or color show),
turn the switch off, then back on again within 10 seconds.
When the lights have been off for over 60 seconds, and are first turned on, they will come on to
white for 15 seconds for quick clear view of your pool, then go to the last fixed color or color show
that was running.
Light Synchronization
If your pool or spa has multiple Hayward ColorLogic LED lights, they may be operated independently,
or they can be easily synchronized so they will all display the same colors and shows at the same
time. For light synchronization, all lights must be wired to the same switch. Once installed, all lights
should be automatically synchronized, however, if they get out of sync, they can be re-synchronized
easily.
To re-synchronize your lights, start with the lights off and follow the steps below:
1. Turn lights on.
2. Turn off light for between 11-15 seconds,.
3. Turn lights on.
9
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS