Carbest 82285 Manuel D'utilisation page 16

WARNING
DE
The installation of a fuse must be on positive cable. A missing fuse on the positive
cable between the inverter and battery may cause damage to the inverter and will void
EN
warranty.
IT
INVERTER OPERATION
To operate the power inverter, turn the main switch ON, the power inverter is now ready
ES
to deliver AC power to your loads. If there are several loads, turn them on separately
after the inverter has been ON in order to prevent an electrical overload.
FR
• Set the power switch to the ON position and the buzzer will send out Beep sounds at the
moment the inverter will do self-diagnosis. Then the power status LED indicators will also
show various colors, finally the buzzer will sound another Beep and the power status LED
NL
indicators will turn to green color. The inverter starts working successfully.
• Set the power switch to the OFF position, the inverter stops and all the lights will go off.
FI
DK
TROUBLESHOOTING
SE
WARNING:
Do not open or disassemble the inverter. Attempting to service the unit yourself may
result in a risk of electrical shock or fire.
Problems &
Symptoms
No AC power
output
and status
illuminates
the red LED
MAINTENANCE
Very little maintenance is required to keep your inverter operating properly. You should
clean the exterior of the unit periodically with a damp cloth to prevent accumulation of
dust and dirt.
At the same time, tighten the screws on the DC input terminals.
Carbest Sinus Power Inverter | 82282/82283/82284/82285/82286
Possible cause
Over input voltage (OVP)
Low input voltage (UVP)
Thermal shutdown (OTP)
Short circuit or wiring error.
Over load (OLP)
Solutions
Check input voltage, reduce input voltage.
Recharge battery, check connections and
cable.
Improve ventilation. Make sure ventilation
openings in inverter are not obstructed.
Reduce ambient temperature.
Check AC wiring for short circuit. Reduce
load.
16