WIMIUS P62 Mode D'emploi page 7

support01@wimius.com
Operating Instructions
• To get a better watching, please use this projector while drawing the curtain or in a dark room.
• Please use the projector carefully, dropping or crashing may damage parts or result in blurred images and
abnormal displaying.
1.Getting Started
• Remove the lens cap, connect the projector with the power through power supply cable, it starts work.
• Then boot screen appears, like the picture.
2.Focus and Auto Keystone Correction
(1)Auto Focus and Keystone Correction.
Please place the projector horizontally face to wall first, turn on and then it will automatically focus the picture based
on the projection distance from the screen and adjust the picture to a rectangle. Or press "
keystone correction key directly.
EN
10
If the picture is blurry, press the focus button ''F+'' ''F-'' on the remote control to adjust the lens focus, tap or long
press the adjustment button until the picture is clear.
(2)How to Use Projection Settings
Select the settings icon in the upper right corner
control to enter the settings interface and select "Projection Image Setting". After entering the interface, select the
mode you want in the projection settings, then adjust the keystone as you want.
• Manual Keystone
After going into"Manual Keystone",you can set "4-point Keystone"as your need: Horizontal Value ±96, Vertical Value
from±54
Just click "OK" button to pick the point you want adjust at first, and then press the button " ▶ " or " ▼ " to set the value
needed as shown below.
"Auto focus and
support01@wimius.com
of the main interface, and then press the "OK" key on the remote
EN
11