Publicité
Les langues disponibles
Les langues disponibles
▪ Installation
Let your device breathe. Heat is released from the walls so it is important to leave enough
space around the appliance so the air can circulate.
When install a Heat pipe Refrigerator, ventilation should be considered seriously, please refer to
the following: ·There should be left at least 200 cm³ for ventilation ·The distance between wall
and refrigerator side should be at least 20mm ·The bottom should be left at least 50mm for air
flowing air passing through must not be preheated ·The following four pictures show four
installation ways: ·Entire cooling system should be considered in the ventilation
Turn off your appliance
If the unit is not likely to operate for a long period of time:
▪ Remove all items from your appliance.
▪ Switch off the appliance by setting the thermostat to position "0".
▪ Unplug the appliance.
▪ Clean it thoroughly.
▪
Keep the door open to prevent odors from rising.
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifetime of these
LEDs is normally sufficient for no change to be made. If, however,
and despite all the care taken during the manufacture of your
appliance, the LEDs were defective, please contact your after-sales
service for any intervention.
26
Publicité
