Medisana 88931 Mode D'emploi page 28

GB
3 Operating
18
Vibration button
You can enhance the shiatsu massage at any time with a vibration massage for
your thighs by pressing the vibration massage button
The vibration massage in the upper thigh area can be operated separately.
Switch on the device by pressing O
vibration massage button
Press
vibration massage motors
and both
gentle massage. Press button
intensity massage). The LED located in the middle above illuminates. Press button
a third time and the vibration level increases (highest intensity massage). The
LED located above right illuminates. After button
the vibration massage is switched off and the LED extinguishes.
Do not use the massage device for longer than 15 minutes and
then allow it to cool. Using the device for longer can over-
stimulate the muscles and cause tension instead of relaxation.
The massage can be finished at any time by pressing the
On/Off button.
After each use, switch the device off using the On/Off button
and remove the plug
control unit in its bag
To switch off the device
On/Off button
Press the
heads travel back down to the "Park" position. When this position is reached,
the LED extinguishes. If you press the
massage functions is switched on, the massages in neck/shoulder and seat just
stop immediately, including heat function. First the massage heads in the back
travel downwards to the "Park" position. The LED flashes meanwhile and then
extinguishes.
n/Off button
. The LED located above left illuminates
are switched on. They begin with a
again and the vibration level increases (medium
from the mains socket. Always store
.
power LED begins
. The
On/Off button
.
.
is pressed a fourth time,
to flash and the massage
while one of the