Power Dynamics WT460A Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. POWER ON/OFF
Press to turn the device on/off.
2. LED INPUT INDICATORS
Indicate the current playback mode.
3. USB
USB input, for playback only.
4. INFRARED REMOTE CONTROL
RECEIVER
5. PREVIOUS / VOLUME –
Press to go to the previous track, press
and hold to decrease the volume level.
6. PLAY/PAUSE / PAIRING
Press to start/resume or pause playback. Press and hold to initiate BT pairing.
7. NEXT / VOLUME +
Press to go to the next track, press and hold to increase the volume level.
8. INPUT / WPS / RESET
Press to change the input mode. Press and hold for 5 seconds to reset to factory settings.
Press simultaneously with WPS button on router (when applicable) to initiate quick pairing.
9. CHANNEL 1 LEVEL
Rotate to change the volume level of channel 1.
10. CHANNEL 2 LEVEL
Rotate to change the volume level of channel 2.
11. AUX INPUT
Left and right RCA line signal input sockets.
12. CHANNEL 1 + 2 LINE INPUT
Left and right RCA line signal output sockets for both channel 1 and 2.
13. LAN
RJ45 LAN connector for inserting an internet cable.
14. BT ANTENNA
Install the supplied BT antenna to maximize BT reception.
15. WIFI ANTENNA
Install the supplied WiFi antenna to maximize WiFi reception.
16. SPEAKER OUTPUT
Speaker output terminal for connecting speakers to channel 1 and 2.
17. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord. For instructions on how to change the fuse, see "REPLACING THE FUSE".
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
CONNECTING WITH BT
Connecting your BT-device to the amplifier, follow below steps:
1. Turn on BT on your smartphone or tablet.
2. Press the INPUT button until the BT LED is illuminated.
3. Press and hold the PLAY/PAUSE / PAIRING button to discard any existing BT connections and make pairing available.
4. Search for "WT460A" in the BT menu of the smartphone or tablet.
5. Connect with "WT460A". When pairing has been successful, the BT LED will stop flashing.
4