Fanelite CR-66516 Mode D'emploi page 30

5. ASSEMBLY
1. Insert the connecting rod into the hole in the center of the base then
secure it by tightening the nut under the base.
2. Install the two pillars in sequence, please pay attention to the alignment.
For the table version, install only one pillar.
3. Install the handle on the fan head.
4. Place the rear grille on the motor block, taking care to align the notches
on the grille with the 2 lugs on the motor block.
5. Tighten the rear grille lock nut clockwise.
6. Align and place the blade onto the shaft of the motor until it locks in
place.
7. Then secure it by tightening the blade locking nut counter-clockwise.
Be sure to tighten the nut properly. Check that the blade turns well by
turning it manually.
8. Place the front grille on the rear grille and assemble the grilles using
the hoop.
30