KOBE CH-03 Série Manuel D'installation Et Mode D'emploi page 12

Hood Installation
CAUTION: If required to move the cooking
range to install the hood, turn off the power on
an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE.
1. Using references in Table 2 on page 4 and
Measurements and Diagrams on pages 16-17,
mark the leveling point of the hood. Position
two mounting screws (not included) on the wall,
leaving 1/8" away from the wall. Refer to Figure
13.
2. Align hood-mounting bracket to the two screws
on the wall and hook hood into place. Tighten
screws to secure hood to the wall.
3. For safety purpose, pre-drilled mounting holes
are provided through the back of the hood. For
a more secure installation, use as many
mounting holes as needed to secure from the
inside of hood (screws not included).
CAUTION:
SECURE BEFORE RELEASING.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE
HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY SPECIALIZED
ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL
ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK SERVICE PANEL TO
PREVENT
POWER FROM
ACCIDENTALLY.
4. Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with wire
connectors.
black to black, white to white, and green to
green as shown on Figure 14.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire connections
underneath the hood. Make sure wires do
not slip between motor or any moving parts
to prevent any damage.
MAKE SURE HOOD
AND
BEING SWITCHED
Connect according to color:
Figure 13
Figure 14
IS
LOCAL
ON
10
WALL