Bosch DHI 635 HX Mode D'emploi Et Notice De Montage page 27

Preparing the wall cupboard
3. Align and screw on the enclosed
mounting rails.
Note the thickness of the sides of the
cupboard (16 mm or 19 mm).
dimension X.
x=16mm
X
If the interior depth of the cupboard is
less than 280 mm, the 250 mm high rear
panel must be removed.
x=19mm
Installation inside the wall
cupboard
1. Remove the filter frames (see Operating
Manual).
2. If the hinges are no longer accessible
when the extractor hood has been
installed, align the cupboard doors.
3. Lift and push the extractor hood from
below into the cupboard until the
installation aids on the left and right lock
into position.
4. Pull out the filter drawer all the way.
5. Attach the extractor hood by screwing
in 2 screws on the left and right. Do
NOT tighten the screws. Raise the
extractor hood.
6. Align the extractor hood in the
cupboard and tighten the screws.
27