Télécharger Imprimer la page

Poulan Pro CO17542LT Manuel De L'opérateur page 7

Publicité

SEAT PAN
FLAT WASHER
LOCK WASHER
ADJUSTMENT
BOLT
CHECK BATTERY (See Fig. 3)
Lift seat pan to raised position.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE section of this
manual for charging instructions).
SEAT PAN
TERMINAL
ASSEMBLY
SHOULDER
SEAT
BOLT
02465
FIG. 2
LABEL
TERMINAL
FIG. 3
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and func tion of
con trols)
Press lift lever plunger and raise attachment lift lever
to its highest po si tion.
Release parking brake by depressing clutch/brake
ped al.
Place gearshift lever in neutral (N) po si tion.
Roll tractor forward off skid.
Remove banding holding deflector shield up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Op-
er a tion sec tion for lo ca tion and func tion of
con trols)
WARNING: Before starting, read, un der stand and follow
all in struc tions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
Be sure all the above assembly steps have been com-
pleted.
Check engine oil level and fill fuel tank with gasoline.
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
Place gear shift lever in neutral (N) position.
Press lift lever plunger and raise attachment lift lever
to its highest position.
Start the engine. After engine has started, move throttle
control to idle position.
Depress clutch/brake pedal into full "BRAKE" position
and hold. Move gearshift lever to 1st gear.
Slowly release clutch/brake pedal and slowly drive
tractor off skid.
Apply brake to stop tractor, set parking brake and place
gearshift lever in neutral position.
Turn ignition key to "OFF" position.
Continue with the instructions that follow.
7

Publicité

loading