Beurer UB 66 XXL Mode D'emploi page 13

4.4 Selecting the temperature setting
To increase the temperature, press the
After switching on the temperature setting is illuminated.
Setting 0: OFF
Setting 1: minimum heat
Setting 2-3: Individual heat
Setting 4: maximum heat
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overheat-
ing of the user.
NOTE:
• The quickest way to heat up the heated underblanket is to select the highest temperature setting
of the switch, first.
• We strongly recommend switching on the heated underblanket approx. 30 minutes before going to
bed and covering it with the quilt to prevent the warmth from escaping.
4.5 Automatic switch-back
NOTE:
This electric underblanket features an automatic switch-back for safety purposes. Temperature settings
4 and 3 are automatically switched to temperature setting 2 after 3 hours.
4.6 Automatic switch-off
This electric underblanket is equipped with an automatic switch-off. This turns off the heat supply 12 hours
after the electric underblanket is first switched on. This is indicated by a flashing temperature setting. In order
to reactivate the electric underblanket, the sliding switch (4) must initially be set to off ("0" position). After about
5 seconds it is possible to switch it on again. If the electric underblanket will not be used after timed switch-off,
it should be switched off (sliding switch to position "0") and the mains plug removed from the mains socket.
4.7 Switching off
Set the ON/OFF slider (4) to the OFF (0) position to switch off the electric underblanket. After switching off
the temperature setting is not illuminated any more.
NOTE:
If the heated underblanket won't be used for several days, switch it off (Slider to setting "0"/OFF) and
remove the supply plug from the mains outlet.
5. Cleaning and care
WARNING
Always remove the supply plug from the mains outlet and remove the
switch from the heated underblanket by disconnecting it at the con-
nector.
CAUTION
• The switch must never get in contact to water or other liquids. Otherwise the switch may be dam-
aged.
button (6). To decrease the temperature, press the
13
button (7).