GRE WHEELS VAC SC600 Manuel D'instructions page 5

ASSEMBLING THE CLEANER
The "Wheels Vac" Aboveground Suction Side Pool Cleaner
body is shipped as one piece, making cleaner assembly a
simple and quick process.
Hose Assembly
For best results and to maintain proper operation, use only
original Gre parts and hoses.
1. To connect the hose sections, wet the ends in the pool
water, then twist and push the female ends onto the
male ends.
Figure 2
Male Hose End
2. Connect the leader hose to the cleaner swivel. See
Figure 3.
Note: The leader hose is 36 centimeters (14 inches) in
length and shorter than the other sections included in
the hose set. Failure to use this leader hose section will
hinder cleaner performance.
3. The hose should reach from where the cleaner is
connected to the farthest point of the pool, plus one
section and the leader hose.
4. Install the hose float onto the second length of hose. The
float should be placed 51 centimeters (20 inches) above
the cleaner. See Figure 4.
5. Make sure that all connections are snug.
6. The overall length of hose needed will be determined by
the distance from the point at which you attach the hose
to the suction port to the furthest point in the pool, plus
one length and the leader hose. Refer to Figure 5.
Female Hose End
Figure 3
Figure 4
5
Leader
Hose
Swivel
Assembly
51 cm
(20 in)
Figure 5