LG LRSXS2706 Serie Manuel Du Propriétaire page 14

14 INSTALLATION
NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only present on some models.
Assembling the Freezer Door
1
Install the freezer door onto the bottom hinge
pin .
a
2
Fit the hinge over the hinge lever latch
b
and slot it into place. Rotate the lever
clockwise and fasten the hinge.
NOTE
• Align the freezer door with the cabinet to help fit
the top hinge in place.
3
Connect all the wire harnesses and the
ground wire.
4
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only present on some models.
5
Hold the water supply connection and gently
push in the collet
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
c
place.
d
NOTE
• Disassembling/Assembling the Water Lines
Collet
f
to connect the water
e
Tube Insert line
g h i
Clip