hestan KVI Serie Instructions page 17

INSTALLATION
A
B
MODEL WEIGHT
KVI36 95 lbs.
[42 kg]
KVI42 116 lbs.
[53 kg]
KVI54 188 lbs. 42 in. [106.7 cm]
[85kg]
5. Prepare a protective surface on the floor or countertop for the hood. Remove the hood from
its packaging, and set the transition aside. Then place the hood upside-down on the protective
surface for access to the inside of the hood.
6. Remove the blower shield(s) and blower housing(s) as follows:
a) Remove the shipping tape that is securing the blower shield(s) inside the hood.
b) Remove the blower shield(s) as described in BLOWER SHIELD REMOVAL on page 6.
c) Gently close the back draft damper(s) from the top side of the hood.
d) Remove the blower housing(s) as described in BLOWER HOUSING REMOVAL on page 6.
7. Remove the blower deck assembly by removing the 12 screws around the blower mounting
plate. Unplug the electrical connector(s) and set the blower assembly aside, taking care not to
damage the blower wheels.
(CONT.)
KVI36, KVI42, KVI54 DIMENSIONS
INCLUDED
TRANSITION
12"
[30.5 cm]
A
24 in. [61.0 cm] 36 in. [91.4 cm]
30 in. [76.2 cm] 42 in. [106.7 cm]
54 in. [137.2 cm]
MAKE SURE POWER IS OFF AT THE SUPPLY PANEL / BREAKER
DURING SERVICE OR INSTALLATION.
17-7/8"
[45.4 cm]
32-15/16"
[83.6 cm]
B C
3 in. [7.6 cm]
3 in. [7.6 cm]
5-1/4 in. [13.3 cm]
©2019 Hestan Commercial Corporation
C
18"
[45.7 cm]
Duct Connection
8 in. [20.3 cm]
8 in. [20.3 cm]
12 in. [30.5 cm]
13
EN