ADJUSTING THE HEIGHT OF THE UPPER RACK
You can adjust the height of the upper rack in your Samsung dishwasher so that the lower rack can
accommodate larger sized dishes. Depending on where you set the upper rack height, the lower rack can
accommodate plates up to 14 in. (36cm) in diameter and the upper rack can accommodated plates up to
12 in. (30cm) in diameter.
DW7933 Series
The upper rack has two sets of rollers on each side, one above the other.
To adjust the height of the upper rack, follow these steps:
1. Remove the upper rack following the directions in Removing the
Upper Rack below.
2. To lower the upper rack (if you have raised it), you remove it, and then
re-install it with the upper set of rollers resting on the rack supports as
shown in Figure A to the right.
3. To raise the upper rack, you remove it and then re-install it with the
lower set of rollers resting on the rack supports as shown in Figure B
to the right.
We recommend adjusting the height of the upper rack before loading
dishes into the rack. If you adjust the the rack after loading the
CAUTION
dishes, you may damage the dishes.
REMOVING THE UPPER RACK
Pull the upper rack towards the front and then remove it by lifting it up slightly and pulling it towards the
front. See the illustrations below.
While the upper rack is removable, it must be installed for the dishwasher to operate properly.
If you attempt to operate the dishwasher without the rack, noise will occur and the dishwasher will
CAUTION
perform poorly.
Step 1.
DW7933LRASR-00141A-02_EN.indd 15
DW7933LRASR-00141A-02_EN.indd 15
Step 2.
Using your dishwasher _15
Step 3.
2012-09-05
2012-09-05
12:09:07
12:09:07