Publicité
Les langues disponibles
Les langues disponibles
3. Measure the time in seconds until the liquid thread breaks off. This flow
time is called DIN-s. Thin the material as much as necessary until the
liquid thread already breaks off after approx. 20 seconds.
Paint Jet Adjustment
For a high jet (vertically), align the nozzle (1g)
horizontally. Use this setting for spraying
larger areas.
For a wide jet (horizontally), align the nozzle
(1g) vertically.
Operation
1. Before starting work, check the trigger (1e) to make sure it moves
freely.
2. The paint flow regulator (1c) is completely shut by factory default. Turn
the paint flow regulator counter clockwise to open it. Turn the fan
regulator (6) counter clockwise until the first thread pitch is visible.
Open the air flow regulator (1f) by turning counter clockwise.
3. Connect the spray gun to the compressed air supply. The air should be
regulated and filtered.
4. Setup the air pressure according to the parameters supplied with the
paint to be processed.
5. Perform test runs on some test pieces. This way you can determine the
optimum amount of paint and the different paint jet adjustments.
Hints for Operation
Note the parameters given by the manufacturer of the coating materials
to be used. Pour the material to be processed in the paint cup (1b) and
carefully close the cup with the lid.
Pay attention that the hole in the lid is free at all times.
Pay attention to the air hose when painting.
Hold the hose firmly with one hand while operating the spray gun with
the other hand. The hose must not be bent. Do not step on it, as this
will lead to formation of droplets.
The movement speed of the spray gun depends on the setting of the
paint flow regulator (1c). With little paint, move the spray gun slowly.
All manuals and user guides at all-guides.com
1) Gravity Spray Gun
26
Publicité
