Publicité
Les langues disponibles
Les langues disponibles
How to use the remote control
To start unit
POWER - Press the Power button once. The unit will automatically
1
turn on in the mode and fan speed it was last left on.
To set mode of operation
2
COOL - Press the Cool button to automatically switch the operating
mode to COOL.
3
FAN ONLY - Press the Fan Only button if you want to run the fan only.
You may want to use this feature in conjunction with the Fresh Air/
Exhaust if you want to bring outside air into the room, or exhaust stale
air. (The FRESH AIR / EXHAUST feature is located on the front of the
air conditioner near the top. See Figure 9 on page 7.)
MoneySaver
- Press the MoneySaver
4
®
MoneySaver
feature. This cycles the fan with the compressor so
®
that the fan does not run all the time.
To adjust temperature
5 COOLER - Press the
setting.
6 WARMER - Press the
setting.
To adjust fan speed
7
FAN SPEED - Press the Fan Speed button to see the current set-
ting. Press again to change the fan speed. F1 is the lowest setting
(SLEEP SETTING), F2 is low speed (LOW), F3 is medium (MED),
and F4 is high (HIGH).
To set the hour clock
8
SET HOUR CLOCK - Press Set Hour once to see the current clock set-
ting. Continue pressing the button until you arrive at the current time.
MAKE SURE YOU SET THE A.M. AND P.M. PROPERLY. (NOTE:
MINUTES ARE NOT SHOWN ON THE DISPLAY.) A light will appear in
the upper left corner of the display when the hour is P.M.
* A Friedrich RC1 wireless remote control can be used to operate all
QuietMaster
Programmable models.
®
button to activate the
®
Cooler button to raise the temperature
Warmer button to lower the temperature
920-198-00
*
(QuietMaster Programmable)
To set the timer
NOTE: Set the hour clock before attempting to set timer functions. You
can set the timer On/Off a minimum of one hour apart, and a maximum
of 23 hours apart.
TIMER START - Press Start to view the current start time for cool-
9
ing. Continue pressing the Start button until you arrive at the start
time you desire. The start time for cooling will then be set.
TIMER STOP - Press the Stop button. Continue pressing the Stop
10
button until you arrive at the stop time you desire. The stop time for
cooling will then be set.
TIMER ON/OFF - Press the On/off button once to activate (light
11
on) or deactivate (light off) the timer. Once the Start and Stop times
have been selected, they will remain in memory, and cycle daily until
changed.
NOTE: If the unit is unplugged or the power is interrupted, the HOUR
CLOCK must be reset or the Timer On/off functions will not work.
Figure 4
6
2
3
11
9
Temperature
Cooler
Warmer
Cool
Power
Fan
Fan
Money
Only
Speed
Saver
®
Timer Operation
On/Off
Start
Stop
Set Hr.
5
1
4
7
8
10
5
Publicité
