Jeep Phoenix Fat Manuel D'utilisation page 26

Preservation and storage
If the electrically power assisted cycle needs to be stored and will not be used for extended periods of time, it must be kept
in a dry, cool, closed space, that is ventilated if possible. The following operations should also be carried out:
• Carry out a general cleaning of the electrically power assisted cycle.
• Remove the battery supplied with the electrically power assisted cycle from its own housing and, after having disconnect-
ed it through the specific key or switch (if present), store it in a dry place away from flammable materials (for example
materials that could explode in flames), with preference at an internal temperature of 15-25°C, never lower than 0°C or
higher than + 45°C, and carry out periodic charge cycles to prevent the voltage level of the same from dropping excessive-
ly, with the risk of damage and loss of efficiency.
• Protect the exposed electrical contacts with anti-oxidising products.
• Grease all surfaces that are not protected by paint or anti-corrosion treatments.
CAUTION
Do not keep or store the bike outdoors or inside a vehicle for a prolonged period of time. Excessive sunlight, overheating, and
excessive cold accelerate tyre ageing and jeopardize the life of both the item and the battery. Do not expose it to rain or water
or immerse it in water to wash it.
Lifting
The weight of the electrically power assisted cycle means it must be lifted by two adults taking extra care to avoid the risk of
personal harm (crushing and injury) or damage to property (knocks and impacts).
DANGER
Transportation
To ensure the safe transport of the pedal-assisted bicycle, inside the passenger compartment of the vehicle used for
transport or outside (e.g. bicycle carrier), in addition to providing for the preventive removal of the battery and the accessory
components installed on it, perform the relative anchoring through the use of appropriate fastening materials (bands or
cables) and coupling devices in good condition and installed so as not to damage the frame, cables and other parts of the
product.
It is the user's responsibility to ascertain the suitability of the equipment used to transport the bike by fitting and installing
devices (e.g. bike racks) in accordance with the legal requirements of the country in which it is ridden.
CAUTION
The manufacturer is not liable for any breakages caused by lifting and/or transporting the electrically power assisted cycle
after delivery.
25