Toro Recycler 55cm Manuel De L'opérateur page 7

Note: To raise the mower, move all the cutting height
levers rearward. To lower the mower, move all the
cutting height levers forward (Figure 9).
1. Raise the mower
Note: The cutting height settings are 1 inch (25 mm);
1-3/8 inches (35 mm); 1-3/4 inches (44 mm); 2-1/8
inches (54 mm); 2-1/2 inches (64 mm); 2-7/8 inches (73
mm); 3-1/4 inches (83 mm); 3-5/8 inches (92 mm); and
4 inches (102 mm).
Starting the Engine
1. Hold the blade control bar against the handle
(Figure 10).
1. Blade control bar
2. Pull the recoil start handle (Figure 11).
Note: When you pull the recoil start handle, pull it
lightly until you feel resistance, then pull it sharply
Figure 9
2. Lower the mower
Figure 10
(Figure 11). Allow the rope to return to the handle
slowly.
Note: If the mower does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-propel Drive
To operate the self-propel drive, squeeze the self-propel
drive bar (Figure 12) toward the handle and hold it.
1. Self-propel drive bar
To disengage the self-propel drive, release the self-propel
drive bar.
Note: The maximum self-propel ground speed is fixed.
To reduce the ground speed, increase the space between
the self-propel drive bar and the handle.
Stopping the Engine
To stop the engine, release the blade control bar.
Important: When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.
7
Figure 11
Figure 12