senya SYBF-CJ018N Notice D'utilisation page 28

2. Above the base, place the juicer bowl, clip it firmly and ensure that it is securely attached
to the base of the device.
3. Assemble the filter and the pressing screw. Place the pressing screw over the filter and turn
the pressing screw anti-clockwise to clip the two parts together.
4. Then insert the set into the juicer bowl, then press down on it to secure the set.
5. Place the feeding tube over the juicer bowl. Ensure that the "white triangle" symbol on the
top cover is aligned with the "lock open" symbol on the juice bowl. Then turn the top cover
clockwise to the end. The "white triangle" symbol marked on the top cover will now be
aligned with the "lock closed" symbol on the juicer bowl.
6. Insert the push-button into the feeding tube
Caution: The device operates even if the lid is not locked properly. Be careful to
assemble all parts of the juicer correctly and lock the lid securely.
IV-3 USE
1. Wash the fruits and/or vegetables you want to use, then cut them to fit into the feeding
tube.
2. Remove all hard and inedible skins (the skin of melons, pineapples, mangos, etc.) before
juicing.
3. Ensure that the device is properly locked.
4. Position the pulp collecting container under the spout for the pulp and position the juice
collecting container under the spout for the juice.
5. Connect the device and turn the switch to the "on" position (the on/off button must be
facing upwards). Place the pre-cut pieces in the feed chute and gently press with the push-
button until all the fruits and vegetables pass into the juicer.
6. The juice will flow directly into the appropriate container, as will the pulp.
7. After use, set the switch to "off" (the on/off button must be positioned in the middle).
Disconnect the device and then disassemble it.
Note: Do not put your fingers or any other objects into the feed chute during
operation
IV-4 DISASSEMBLING THE JUICER
1. Ensure that the juicer is off and the power cord is unplugged from the power socket
2. Remove the juice container and the pulp container
3. Remove the feeding tube by turning it anti-clockwise
28