Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
The coffee is delivered too slowly or a
drop at a time.
The machine does not make coffee
Coffee does not come out of one or both
spouts.
The coffee delivered is watery.
The infuser cannot be extracted.
At the end of descaling, the appliance
requests a third rinse
The milk has big bubbles
Milk beverages are not enabled
The cup tray on top of the machine is hot A number of beverages have been pre-
The machine emits noises or small puffs
of steam while not in use
The appliance emits puffs of steam from
the drip tray and/or there is water on the
surface the appliance rests on.
POSSIBLE CAUSE
The coffee is ground too finely.
Impurities have been detected in the in-
ternal circuits
The coffee nozzles are blocked.
The pre-ground coffee funnel is clogged.
The machine has not been turned off.
During the two rinse cycles, the water
tank has not been filled to the MAX level
The milk is not cold enough, or is not
semi-skimmed or skimmed.
The milk container lid is dirty.
Vegetable beverages are being used.
The milk container is not correctly insert-
ed, or there is not enough milk to prepare
the requested beverage.
Several milk beverages have been pre-
pared in succession and the machine
needs to heat up to the ideal temperature
before making the next beverages.
pared in rapid succession
The machine is ready for use, or has re-
cently been turned off, and condensate is
dripping into the hot vaporiser.
The drip tray grille has not been replaced
after cleaning.
31
REMEDY
Adjust the grinding level ("4.6 Adjusting
the coffee mill"). The effect is not visible
until at least 2 coffees have been made.
Wait until the machine is ready for use
again, and proceed to select the required
beverage. Contact customer services if
the problem persists.
Clean the nozzles with a cloth. Any en-
crusted deposits can be removed with a
toothpick, if necessary.
Open the door and clean the funnel with
the help of a brush.
Turn the machine off by pressing the
button.
Empty the drip tray, fill the tank up to the
MAX level and perform the third rinse cycle.
Use skimmed or semi-skimmed milk at
refrigerator temperature (about 5° C). If
the result is not as expected, try a differ-
ent brand of milk.
Remove the components and clean them
thoroughly as described in section "12.
Cleaning the milk container".
The effect varies widely depending on the
nutritional properties of the beverages.
Prepare the milk container and insert it
correctly in the machine.
Wait until milk beverages are again ena-
bled on the control panel.
This is part of normal operation. To limit
the phenomenon, empty the drip tray.
Put the grille back in the drip tray.
Publicité
