Publicité
Les langues disponibles
Les langues disponibles
•
Whenever the machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of scalding!
During rinsing, a little hot water flows from the coffee spouts.
Take care to avoid contact with splashes of water.
•
To turn the appliance on or off, press the
If you will not be using the appliance for some time, unplug
from the mains socket.
4. MAKING COFFEE BEVERAGES
4.1 Making coffee using coffee beans
•
Do not use green, caramelised or candied coffee beans as
they could stick to the coffee mill and make it unusable.
•
If "Energy Saving" mode is activated, there may be a few
seconds delay before the first coffee is delivered.
4.2 Making coffee using pre-ground coffee
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the machine.
•
Never use more than one level measure as it could dirty
the inside of the machine or block the funnel.
LONG coffee: halfway through prepara-
•
Making
tion, when the
level measure of pre-ground coffee and press the Long
button again.
•
You cannot make
ground coffee.
4.3 Varying the coffee aroma
1. Press the button corresponding to the preferred aroma:
2. Select the desired coffee beverage.
Please note:
•
When the next coffee is made, the machine will propose
the last aroma selected.
•
In the event of power failure, the machine will revert to
the medium default setting.
4.4
Rinsing
Use this function to deliver hot water from the coffee spouts to
clean and heat the appliance's internal circuit.
button.
+
lights come on, add one
Doppio+ coffee using pre-
Mild
Medium
Strong
To perform the rinse cycle, just press and hold the
for about 5 seconds. Delivery stops automatically (to interrupt
delivery earlier, press the same button again).
4.5 Tips for a hotter coffee
To make a hotter coffee, proceed as follows:
•
perform a rinse cycle (see paragraph "4.4 Rinsing");
•
warm the cups by rinsing them first using the hot water
function;
•
increase the coffee temperature (see section "10. Settings
menu").
4.6 Adjusting the coffee mill
The coffee mill is set by default to prepare coffee correctly and
should not require regulating initially.
To adjust, while the coffee mill is in operation, turn the dial as
follows:
If the coffee is delivered too
slowly, or not at all.
This adjustment will not take ef-
fect until at least 2 cups of coffee
have been delivered.
For a fuller bodied creamier
coffee
This adjustment will not take ef-
fect until at least 2 cups of coffee
have been delivered.
Please note:
The grinding adjustment dial must only be turned when the
coffee mill is in operation during the initial phase of coffee
preparation.
4.7 Customising the quantity in the cup
1. Press the button relative to the beverage being pro-
grammed and hold for a few seconds: the programming
19
button
Turn one click towards "7"
Turn one click towards "1"
Publicité
