Publicité
Les langues disponibles
Les langues disponibles
8. Remove a screw from the door hinge.
The screw is for pre-fixing the door to the frame front.
9. Reassemble the screw in the other hole.
10. Place the door on the other side and reattach it to the dryer.
11. Reattach the holder lever.
12. Reattach the screws in the remaining holes.
Final installation checklist
•
The dryer is plugged into an electrical outlet and is properly grounded.
•
The exhaust ductwork is hooked up and the joints are taped.
•
A plastic flexible duct is NOT used.
•
Use rigid or stiff-walled flexible metal vent material.
•
The dryer is level and is sitting firmly on the floor.
•
Gas models – the gas is turned on with no gas leaks.
•
Start your dryer to confirm that it runs, heats, and shuts off.
DV6000HA_DC68-03380A.indd 21
English - 21
2013-12-19
1:07:50
Publicité
