Keurig HOT PLUS Série Guide D'utilisation Et D'entretien page 39

BREWER SHUTS OFF OR TURNS ON AUTOMATICALLY
• Check to make sure that the AUTO ON/OFF settings have not been set
(refer to page 20).
THE TOUCH DISPLAY INDICATES "MORE WATER PLEASE."
• If the water level is not low, remove the Water Reservoir and empty the water.
Then thoroughly clean (refer to page 25). Fill the Water Reservoir to the MAX FILL
line, return it to the brewer, and ensure it is seated properly in its Base.
THE TOUCH DISPLAY INDICATES "SORRY, BREW INTERRUPTED."
OR "SORRY, THERE IS A PROBLEM."
• These screens indicate there are coffee grounds stuck in the Entrance Needle. Use caution
and slowly lift the Handle and remove the pod from the brewer. To release the clogged
needle, use the Brewer Maintanance Accessory included with your brewer. Refer to the
instructions on page 28 or the guide included with the Accessory.
THE K-CUP POD HAS A KEURIG
®
INDICATES "OOPS!"
• Keurig cannot guarantee that pods without the Keurig
Series brewer. Some Keurig
enabled to work with the Keurig
1.800.361.5628 for a solution.
STILL HAVING TROUBLE? VISIT KEURIG.CA FOR MORE INFORMATION.
LOGO, BUT TOUCH DISPLAY
®
brand pods produced prior to January 2014 may not be
®
Plus Series brewer. Please contact Customer Service at
®
39
3 | TROUBLESHOOTING
logo will work in the Keurig
®
Plus
®