Trevi 206 Instructions D'assemblage page 20

8
1) Add sand.
2) Choose the filter location beside a round section (never in a
straight section). The starting point should be at that location where
the skimmer and return holes are, and as close as possible to the
filtration system.
3) Before uncoiling the wall, make sure the pre-punched holes for
the skimmer and pump return are at the top and facing the planned
location of your filter.
SAND
Begin inserting the wall into the bottom tracks in the middle of a
bottom plate. At first, the wall is kept in place with one or two pegs
and strings (or extra persons). One person uncoils the wall on a
beam or a plank, while a second person inserts it in the bottom
tracks. Do not uncoil more than 3 m (10') of wall before you install
a support bar or peg and string to reinforce the structure.
Once the wall is completely uncoiled, you may find that it is too
long or that both ends do not meet by a few centimetres. If such is
the case, adjust tracks and bottom plates until wall holes line up. If
this does not work, roll up the wall again, realign the grooves and
uncoil the wall again. If the spread is too wide, measure the wall
and check it against the chart below.
Illustration 8.1
Inside of pool
BOLT
IMPORTANT! Installing the wall joint in non-compliance with the specifications dictated by the manufacturer will void the warranty.
A faulty installation will cause the wall/joint to split which could result in serious and/or fatal injuries!
Chart MODELS
ACTUAL LENGHT
OF THE WALL
WALL INSTALLATION
PLANKS D
PEGS AND
STRINGS
End
NUT
Outside of pool
10x16 10x19 10x22
43' 8" 49' 8" 55' 9"
(13,30m) (15,14m) (17,00m)
Join both ends of the wall by orienting folds outward to hide the ex-
clamation icon. (Illustration 8.1)
Note: If the wall is attached properly, you should no longer see
the exclamation icon. If you can always see the icon, you must
reverse the overlap.
Insert bolts and nuts in every hole and tighten with wrench (screw
head on water side of wall). Tape over screw heads with duck tape.
Do not use impact gun for wall
screws.
Minimum torque force of 60 inch
pounds to maximum of 85 inch pounds.
12x18 12x24 15x24
12x21
49' 8 1/2" 61' 9 3/8" 65' 2 1/2"
55' 9 3/8"
(15,16m) (18,83m) (19,88m)
(17,00m)
End
BOTTOM PLATE
Fold
15x30 18x33
77' 2 1/2" 86' 7 1/2"
(23,53m) (26,40m)
Inside of pool
Outside of pool
Fold