MSI MS-7597 Mode D'emploi page 15

installing Memory Modules
. the memory module has only one notch on the center and will only fit in the
right orientation.
2. insert the memory module vertically into the diMM slot. then push it in until
the golden finger on the memory module is deeply inserted in the diMM slot.
the plastic clip at each side of the diMM slot will automatically close when the
memory module is properly seated. you can barely see the golden finger if the
memory module is properly inserted in the diMM slot.
. Manually check if the memory module has been locked in place by the diMM
slot clips at the sides.
iMPoRtant
* in dual-Channel mode, make sure that you install memory modules of the same
type and density in different channel diMM slots.
to enable successful system boot-up, always insert the memory modules into
*
the diMM first.
notch
Volt
MS-7597
5