Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
EN
This instruction manual contains important informa-
tion and must be read carefully by competent persons
prior to any handling, transport, inspection or instal-
lation of this product. Every care has been taken in the
preparation of the instructions and information; how-
ever, it is the responsibility of the installer to ensure
the system complies with relevant national and inter-
national regulations, especially safety. The manufac-
turer, Soler & Palau Sistemas de Ventilación S.L.U.
accepts no responsibility for breakages, accidents or
any inconvenience caused by failure to comply with the
instructions contained in this manual.
The fan units referred to in this manual have been
manufactured in accordance with rigorous quality
control and International standard ISO 9001. Once the
product has been installed, this manual to be retained
by the end user.
TRANSPORT AND MANIPULATION
The packaging used for this fan unit has been de-
signed to support normal transporting conditions.
The fan unit must always be transported in its original
packaging as not doing so could deform or damage
the product. Do not accept delivery if the fan is not in
its original packaging or shows clear signs of having
been damaged.
The product should be stored in a dry place in its orig-
inal packaging, protected from dust and dirt until it is
installed in its final location.
Do not place heavy weights on the packed product and
avoid impact damage.
Any lifting equipment must be safe and of suitable ca-
pacity for weight and size. Special attention may be
required to ensure fan assembly does not distort or tilt
as weight distribution may vary. Never lift a product by
pulling it by the wires or terminal casing. Likewise, no
pressure should be applied on the propeller, turbine
or safety grid while manipulating the product.
STORAGE
Storage must be in a safe, flat, controlled environment
to prevent damage, especially from water, sand, dust,
moisture, corrosion, temperature. Recommend that
duct connections (inflow and outflow) are closed to
avoid dust/debris entering the equipment.
These data may also apply to an installed fan, which is
not put into operation for extended period.
14
IMPORTANT INFORMATION
FOR THE SAFETY OF
INSTALLERS AND USERS
• Installation must be carried out
by qualified persons acting in ac-
cordance with all safety precau-
tions applicable and as required
by law, regulations and stand-
ards in the country applicable.
• All fan units are designed and
manufactured
with EC Directive. Safety guard
accessories are available from
S&P if required due to specific
installation.
• Working ambient temperature
for fan unit equipment should
not be exceeded typically this
will be within -20°C to +40°C,
unless stated otherwise.
• This fan unit must not be used
in explosive or corrosive atmos-
pheres.
• Precautions must be taken to
avoid the back-flow of gases into
the room from the open flue of
gas or other fuel-burning appli-
ances.
• This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental ca-
pabilities or lack of experience
in
accordance
Publicité
