Ryobi PCL700 Manuel D'utilisation page 6

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
CLEANING/REPLACING THE FILTER
See Figure 8, page 8.
 Remove the battery pack.
 Depress the release button located on the nozzle.
 Remove dust bowl, filter housing, and filter from vacuum.
 Remove filter housing and filter from dust bowl.
 Turn filter counterclockwise and remove it from filter
housing.
NOTE: To reassemble, insert filter into filter housing and
turn clockwise to lock into place.
 Shake or lightly brush any dust or dirt off the filter.
 Shake or lightly brush any dust off the filter housing. Wash
if necessary.
 Empty the dust bowl; wash if necessary. Before reattach-
ing to the hand vac, make sure all pieces are completely
dry.
NOTE: Allow 24 hours for parts to dry completely.
When purchasing replacement filter, request recommended
part number 542363003.
NOTE: ILLUSTRATIONS START ON PAGE 7 AFTER
MAINTENANCE
FRENCH AND SPANISH LANGUAGE SECTIONS.
REMOVING THE ROLLER BRUSHES FOR
CLEANING
See Figure 9, page 8.
The roller brush is located inside the the mini beater bar. The
roller brush has a tool-free end cap, allowing it to be easily
removed for cleaning.
To remove:
 Remove the battery pack.
 Insert a coin into the slot on the end of the roller brush.
Rotate the end cap approximately 1/4 in. counterclockwise
to unlock the roller brush.
 Slide the brush to release the cap and pull the brush from
the mini beater bar assembly.
NOTE: Use scissors to remove any threads or hair wrapped
around the roller brush using the scissor grooves.
To reattach:
 Insert the roller brush into the mini beater bar assembly.
 Align the tabs on the cap to the notches on the assembly
and firmly press the cap into place.
NOTE: Make sure the opposite end of the roller brush is
aligned to the drive spindle when pressing the cap into
the assembly housing.
 Turn the end cap 1/4 in. clockwise with coin to lock into
place.
6 — English