AEG DF 6164 Manuel D'utilisation page 4

4 www.aeg.com
The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
50cm from electric cookers and 65cm from
gas or mixed cookers. If the instructions for
installation for the gas hob specify a greater
distance, this must be adhered to.
4. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the hood
from the electrical supply by switching off at
the connector and removing the connector
fuse. Or if the appliance has been
connected through a plug and socket, then
the plug must be removed from the socket.
The cooker hood should be cleaned
regularly (at least with the same frequency
with which you carry out maintenance of the
fat fi lters) internally and externally. Clean
using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning! Failure to carry out the basic
cleaning recommendations of the cooker
hood and replacement of the fi lters may
cause fi re risks. Therefore, we recommend
observing these instructions.
The manufacturer declines all responsibility
for any damage to the motor or any
fi re damage linked to inappropriate
maintenance or failure to observe the above
safety recommendations.
4.1 DF 4160
The glass be dismounted and cleaned
using a normal glass detergent.
Instructions for removing the glass:
1. Remove the grease fi lter.
2. Lightly push the glass downwards and
allow it slide forwards.
3. Remove the glass allowing it to rotate
slightly.
After cleaning, follow the instructions in
reverse to remount the glass.
4.2 Grease fi lter
The grease fi lter must be cleaned once a
month using non aggressive detergents,
either by hand or in the dishwasher, which
must be set to a low temperature and a
short cycle. When washed in a dishwasher,
the grease fi lter may discolour slightly, but
this does not affect its fi ltering capacity.