Vonyx 170.335 Manuel D'instructions page 5

13. Microphone ON/OFF switch
• Button not pressed: received no signal from wireless microphones.
• Button pressed: receive signal from wireless microphones.
14. Battery indicator
LED indicator of the battery capacity and charging.
15. External battery
Connection for alternative power supply from a 12Volt DC source.
16. SD port
Connect your SD/MMC card in this slot to play music with
MP3 or WMA format.
17. Mode button
Press the button to select BT/USB/SD function.
18. Play button
For switching between play and pause.
19. Folder button
Press this button to open the foldermap of USB or SD-card.
20. Repeat button
Press key for repeating of single track or all tracks.
21. Forward - Backward button
For title selection (short actuation) and fast forward/reverse
(long actuation).
22. USB port
Connect your USB devices to this slot to play music with
MP3 or WMA format.
UHF WIRELESS MICROPHONES
Insert the batteries into the wireless microphones (observe the polarity) and turn all volume controls down. Switch the system
ON and the power led will light. Switch the microphones on and increase the Volume knobs to the desired position.
Take care not to incur feedback from the speaker. Turn the Echo and equalizer to a position in order to have the desired sound.
CHARGING BATTERY
Prior to use this system the internal 12V battery need to be charged for 12hours. If the Power-switch is in OFF position and the
system is connected to mains, the battery will be (re)charged and the Charge-Led lights!!
Note: Pull the plug out of the mains outlet if the battery is fully charged!!
Before the device the first time is actuated, please charge the battery at least 12 hours and max. 72 hours! Battery should be
regularly charged. For optimal battery life the battery should be charged at least 1x per month. Please note that if you do not
load within 6 weeks, the battery becomes defective !!
CONNECT BT-DEVICE
1.
2.
3.
If password is required, you can enter "0000".
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Set the search function on of the BT device you want to play the music. See the operating
instructions for that device..
Press the "MODE" button until "AUX" will show in display and activate BT-function.
Find on your BT-device "VONYX AP" and make the connection.
5