icetro WC-0070-AB Mode D'emploi page 23

Checkpoints
Sensor System
1. The Ice Maker is designed to include an ice storage container.
2. When the volume of the ice reaches the preset limit,
ice formation is automatically stopped by a detector sensor.
3. When the ice cubes are taken out from the machine,
the ice detector sensor automatically restarts a new ice
making cycle to produce new ice cubes.
4. The Ice Maker operates as a fixed system.
Maintenance
1. General Maintenance and Check Procedure
① Please observe the installation and operation instructions provided in this User's Manual.
②To maintain the proper condition of the Ice Maker and long-term operation without failure,
perform the maintenance procedures provided below;
2. Inspection of the Ice Maker
Make sure to cut-off the main power supply before servicing the machine.
-
- Check all the lines and joints to prevent leakage.
- Protect the cooling plate from rubbing against another plate and/or vibrating.
- Do not obstruct air way. Allow sufficient ventilation to the Ice Maker.
- Clean the filter installed on the front side of the product at least once a month.
Ice Volume Detector Sensor
23