icetro WC-0070-AB Mode D'emploi page 17

Installation
1. Unpacking the product
- Unpack the product and take out the parts packed inside the produc.
2. Assembling the feet
-Assemble the 4 height adjustable feet on the bottom of the Ice Maker.
3. Level Adjustment
-Adjust the level of the machine with the height adjustable feet.
Lift the front side with the front feet so that the machine is inclined
backwards a little.
(Make the front side higher than the rear side by 1/4-3/8")
4. Ice Maker Drain Hose
-Attach and tighten the snap rings on the drain hose and connect
it to the drain pipe on the bottom of the Ice Maker, using pliers
5. Connecting the water supply hose
-Connect the water supply hose
(rubber hose, outer diameter: Ø1/4") to the water supply
1. The supply water must be from the top water.
2. The pressure and temperature of the supply water must be 1kgf/ ㎠ ~5kgf/ ㎠ (14.22 psig - 71.12 psig),
and 50℉~70℉, respectively.
3. Please be reminded that condensation may form on the door or on the drain hose and flow
Warning
down to the floor.
4. Connect the water supply and drain hoses tightly to prevent unwanted separation.
Drain
Connection
.
Drain Hose
Water
supply hose
Nut elbow
V valve
Elbow V valve
Packing elbow
Clamp
Drain Hose
Nut V valve
17