SMT Monilog MicroShockDetector Guide Rapide page 6

◊ Connect the device to the PC with a USB cable.
◊ Then, press the „New battery" button via the „MONILOG®
Analyzer" software and configure the time by pressing the
„Time synchronisation" button.
◊ The device can now be disconnected from the PC and switched
off or configured as described in
5. On-site assembly
Mount the device at a vibration-stable point of the transpor-
ted goods and switch it on again only after safe installation by
pressing the CONTROL button. This is the only way to determine
the rest position and to avoid premature recording errors.
6. After transport
Switch off the device so that only the relevant measured data is
stored in the memory. The device can then be dismantled.
+49 351 26613 888 | support@monilog.de
Manufacturer:
SMT ELEKTRONIK GmbH
An der Prießnitzaue 22
01328 Dresden
Germany
EN
OUR SERVICE NUMBER:
3.