SMT Monilog MicroShockDetector Guide Rapide page 4

Newly delivered MONILOG® RISK LOGGERS are configured ex
works with default parameters and the measured value memory
is deleted. Therefore, the following steps are optional.
1. Backup of measured data with PC via USB
◊ Switch on the device.
◊ Connect the device to your PC using the USB cable provided.
◊ Start "MONILOG® Analyzer" on the PC and wait until the
transmission of the measured data is complete.
Save the measured data as an ".msd" file. Reports and analyses
can later be generated from this.
2. Reading out and sending reduced measured data with
smartphone via NFC (only for MSD plus)
◊ On your smartphone, launch the
enable NFC on your smartphone.
◊ Press the „READ DATA" button in the app and place the
smartphone in the middle of the MicroShockDetector plus as
shown in the app.
◊ After a few seconds, the data is read out and can be sent by
e-mail with a pdf report and the .msd file attached.
The data read out via NFC is a reduced data record. For a more
detailed analysis of the measured data, they must be read out
completely via PC (USB).
EN
MONILOG® Connect app and