Ryobi RY36PP25A Mode D'emploi page 6

Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
MAINTENANCE
■
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
■
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only.
■
You may only make adjustments or repairs described
in this manual. For other repairs, contact an authorised
service centre.
■
Turn off the product and remove the battery pack before
conducting any maintenance or cleaning work.
■
The saw chain is very sharp. To prevent personal
injury, exercise extreme caution when cleaning, fitting,
or removing the blade cover. Always wear protective
gloves when performing maintenance on the chain.
■
Improper chain maintenance increases the potential of
kickback. Failure to replace or repair damaged chain can
cause serious injury.
■
Follow instructions for lubricating the product and for
checking and adjusting the chain tension.
■
After each use, clean the body and handles of the
product with a soft, dry cloth.
■
Check all nuts, bolts, and screws at frequent intervals
for proper tightness to ensure that the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
Daily check
Bar lubrication Before each use
Chain tension Before each use and frequently
Chain sharpness Before each use (visual check)
For damaged parts Before each use
For loose fasteners Before each use
KNOW YOUR PRODUCT
See page 135.
1. Harness hanger
2. Rear handle
3. Lock-out trigger
4. On/Off trigger
5. Handle adjustment knob
6. Lower shaft
7. Shaft coupling
8. Extension pole
9. Upper shaft
10. Chain lubricant cap
11. Chain
12. Guide bar
6
13. Bar nut
14. Chain tensioning screw
15. Ribbed bumper
16. Harness
17. Guide bar cover
18. Front handle
19. Hex key
20. Operator's manual
21. Lubricant
22. Battery pack
23. Charger
SYMBOLS
Safety alert
Read and understand all instructions
before operating the product. Follow all
warnings and safety instructions.
Do not expose the product to rain or
damp conditions.
Electrical hazard. Keep the product at
10m
least 10 m away from the overhead lines.
Beware of thrown or fl ying objects. Keep
all bystanders a safe distance away from
the product.
Wear non-slip, heavy-duty protective
gloves when handling the pole saw and
the saw chain.
Wear non-slip safety footwear when
using the product.
Wear eye, ear, and head protection.
Do not dispose of waste batteries, waste
electrical and electronic equipment
as unsorted municipal waste. Waste
batteries and waste electrical and
electronic equipment must be collected
separately. Waste batteries, waste
accumulators, and light sources have to
be removed from the equipment. Check
with your local authority or retailer for
recycling advice and collection point.
According to local regulations, retailers
may have an obligation to take back
waste batteries and waste electrical and
electronic equipment free of charge.
Your contribution to the reuse and
recycling of waste batteries and waste
electrical and electronic equipment
helps to reduce the demand of raw
materials. Waste batteries, in particular
containing lithium, and waste electrical
and electronic equipment contain
valuable and recyclable materials, which
can adversely impact the environment
and the human health if not disposed
of in an environmentally compatible
manner. Delete personal data from waste
equipment, if any.