Publicité
Les langues disponibles
Les langues disponibles
REPAIRS
Only use accessories and spare parts recommended by the manufacturer. If the equipment should fail
some day in spite of our quality controls and your maintenance, only have it repaired by an authorized
electrician.
ENVIRONMENTAL PROTECTION
Should your machine need replacement after extended use, do not put it in the
Unwanted batteries should be disposed of in an environmentally friendly way and in
Discharge the battery by letting the machine run at no load speed until the motor stops.
Li-ion
Hand in the battery as chemical waste with the recycling station in your municipality.
TROUBLESHOOTING
Faults
Pump
does
not
start
3. Switch is off
4.
Carbon brush run out
Flow
rate
1. Low voltage of battery
insufficient
2.
blocked
Pump has no or
1. Low voltage of battery
little discharge
2. Impeller blocked
domestic waste but dispose of it in an environmentally safe way.
conformance with the local regulations.
Remove the battery from the machine.
Causes
1.
Disconnect of Li-ion battery
2.
DC breaker triggered
Automatic
switch
blocked
Pump
pedestal
inlet
Made in China
Batteries
1. Connect the battery correctly
2. Reset the DC breaker
3. Turn on the switch
5.
4. Check automatic switch and remove
obstruction
5. Replace carbon brush
1. Replace the battery
grating
2. Use a water jet to clean the pump
pedestal inlet grating
1. Replace the battery
2. Clean impeller and Remove the
obstruction
2020
Remedies
Publicité
