Publicité
Les langues disponibles
Les langues disponibles
Installation
2-2
Connect the input plug to your facility's
compatible AC power source.
2-3
Connect your equipment's input plugs to
the appropriate outlets on the PDU. The
LED near each bank illuminates when
the bank is ready to distribute live
AC power.
Note: It is recommended that you do not
connect a live load to the PDU. If the load you
intend to connect has an ON/OFF switch, please
turn the switch to OFF prior to connection.
2-4
Optional Cord Retention Procedure
Use the included C14 and C20 plastic
sleeves to secure plugs to receptacles.
Attach the sleeve to the plug, making
sure that the pull tabs
the plug and that the fit is secure. To
unplug equipment properly, use the pull
tabs to remove the plug and sleeve from
the receptacle.
Networking the PDU
Your PDU can receive IP address assignments via DHCP server (dynamic) or static (manual)
addressing methods. See the SNMPWEBCARD installation guide for an explanation of
these methods. You can find the guide by going to www.tripplite.com/support and typing
"SNMPWEBCARD" in the search field. If you are uncertain which method to use, contact your
network administrator for assistance before continuing the configuration process.
Note: The MAC address of the PDU (12-digit string in this format: 000667xxxxxx) is printed on a label attached
to the PDU enclosure. For static IP address assignments, use the RJ-45 to DB9 configuration cable (part
number 73-1243) included with the PDU.
14-07-037-9332F9.indb 5
2-2
LINE L1-L2
2-3
remain outside
A
2-4
5
For Installation
Purposes Only
L1-
L2
A
8/15/2014 3:13:09 PM
Publicité
