Konect multi80+ Mode D'emploi page 17

FOAM 0.0V 19.87V
RUN 001:48 0.0W
FOAM 0.0V 19.87V
STOP000:00 0.0W
7> CHECk ESC/MOTOR PPM AND BL MOTOR RPM
7>Esc/Motor PPM
BLMOTOR RPM -->
the check of servo's.
SignalMin: 900us
SignalMax: 2100us
SignalOut: 900us
Motor RPM:-30976
8> THRUST CALCULATOR
8> Thrust Calc
---->
8000RPM 105X60
Th: 977g P:168W
10.00V 20.0A
Pi:200W Ef:84%
9/ MEASURE ExTERNAL TEMPERATURE :
9> Measure Ext.
Tempra: 0C
A>Measure Input Voltage and Output Voltage :
A> Measure VOL
I:12.1V 0:19.87V
Stauts display. The top line shows the foam cut current and voltage.
The second line shows the status and in the lower right comer alternately
displays the output power or tatal run time.
You can stop the test at any time by pressing "Start/Enter".
The new charger incorporates, as the first charger, a fantastic feature which
allows you to check your brushless motors sensors and even measure motor
RPM! In combination with the built-in receiver simulator port you can even
speed-controls for correct function. The receiver simulator port also allows
Press "Start/Enter" button, then press"DEC" or "INC". After setting the min.
and max. signals, press "Start/Enter" button for more than 3 seconds to
start the next ptrocess.
Min. Pules width (range:700~1500us) Max. Pules width (range:1500~2300us).
Status displays. This screen checks out the output signal and motor RPM.
In this program, you can easily calculate the thrust of a propeller.
Press "DEC" or "INC" button, you can set up the RPM, the screen displays the
thrust calculator and its power. After setting the RPM, please press "Start/
Enter" button for more than 3 seconds to start the next process.
In this program, the charger can measure the external temperature by using
a temerature sensor.
In this program, the charger can measure the DC voltage of an object.
17