Konect multi80+ Mode D'emploi page 10

"faSt" cHarging LitHiUM BattEry
The charging current is getting smaller as the process goes to the near end term of Lithium battery
charging. To finish charging process earlier, this program eliminate certain term of CV process. Actually,
the charging current will goes to 1/5 from the initial value to end the process while the normal charging
goes to 1/10 during CV term. The charging capacity may be a bit smaller than normal charging but the
process time will be reduced.
LiPo FAST CHG
2.0A 11.1V(3S)
Li3S 2.0A 12.59V
CHG 022:43 00682
"StoragE" controL LitHiUM BattEry
This is for charging or discharging Lithium battery not to be used for the time being. The program will
determine to charge or discharge the battery to the certain voltage depending on the voltage of the
battery at its initial stage. They are different from the type of the battery, 3.75V for Lilo, 3.85V for LiPo
and 3.3V for LiFe per cell. If the voltage of battery at its initial stage is over the voltage level to storage,
the program will start to discharge.
LiPo STORAGE
2.0A 11.1V(3S)
Li3S 2.0A 12.59V
STO 022:43 00682
DiScHarging LitHiUM BattEry
LiPo DISCHARGE
1.0A 11.1V(3S)
Li3S 2.0A 12.59V
DSC 022:43 00682
10
You can set up the charging current and the voltage of the battery pack being
charged. As you press Start/Enter button the voltage confirmation will be
displayed. And then, if you confirm the voltage and current, press Start/Enter
button again to start charging.
This shows the present state of "FAST" charging. To stop charging arbitrary,
press Batt type/Stop key once.
You can set up the current and the voltage of the battery pack to be charged.
The current will be used for charge or discharge the battery to reach the
"storage" level of voltage.
The screen shows the present situation during charge process. To stop
charging press Batt type/Stop key once.
The value of discharge current on the left side of screen may not exceed 1C for a
maximum safety and the final voltage on the right should not be under the voltage
level that is recommended by the battery manufacturer to avoid deep discharging.
To start to discharge press Start/Enter key for more than 3 seconds.
This shows the present state of discharge. To stop discharging press Batt
type/Stop key once.