Publicité
Installing an expansion card
1.
Remove the metal cover opposite
the slot that you intend to use.
Installing an optical drive
1.
Drive a screw on the top right
screw hole on both sides of the
drive.
3.
Push the drive all the way into the
bay until the drive lock clicks.
4.
Connect a 4-pin power plug from
the power supply unit to the power
connector at the back of the drive.
Installing a SATA hard disk drive
1.
Drive two screws with rubber
washers on both sides of the
drive.
Rubber washer
.
Insert the card connector to the
slot, then press the card firmly
until it fits in place.
.
Connect the IDE and audio cable
at the back of the drive.
.
Connect the SATA signal and
power plug at the back of the
drive.
Power cable
and plug
Signal cable
and plug
Installation Manual
7
Publicité
