HAIRCUT PROFESSIONAL TH36 Manuel D'utilisation page 22

▪ The equipment can be used with the power lead. To do so, connect the cable to
the equipment (Fig. 2) and connect the power pack (Fig. 1-K) to a mains power
socket.
A
DJUSTING THE CUTTING HEIGHT WITH THE LEVER
The cutting height can be adjusted during use of the equipment , with the adjusting
lever (Fig. 1-C):
▪ Push the lever upwards to reduce the cutting height.
▪ Push the lever downwards to increase the cutting height.
U
SING THE COMB ATTACHMENTS
▪ The equipment must be switched off. Select a comb attachment
(Fig. 1 refs. E-J).
▪ Place the comb attachment on the blades and clip in at the rear. When the comb
attachment is correctly fixed, it is immobilized.
R
EPLACING BLADES
▪ Switch the equipment off and unplug the unit from the mains power supply.
▪ Take the screws out of the blades (Fig. 3) and remove the upper and lower cutters.
During their assembly, the upper and lower cutters must be aligned as instructed
below:
▪ Set the adjusting lever to the minimum cutting height.
▪ The distance between the front edge of the lower cutter and the front edge of the
upper cutter must be between 0.8 mm and 1.5 mm.
▪ The upper and lower cutters must be set parallel.
The end tooth on the upper cutter (on the left-hand end) must cover the end tooth
on the lower cutter.
▪ The other end tooth on the upper cutter (on the right-hand end) must also touch
the corresponding end tooth on the lower cutter (on the right-hand end).
▪ Tighten the two screws (Fig. 3).
SERVICING
R
OUTINE SERVICING
▪ After 30 minutes of use, it is advisable to lubricate the blades. Use the lubricating
oil supplied with the equipment (Fig. 1-L).
▪ Lubricate the blades at least once a day (Fig. 4).
▪ After using the equipment each time, clean the blades with the brush supplied
(Fig. 1-M).
▪ If necessary, clean the body of the equipment with a cloth slightly moistened with
water or mild liquid soap. Never use abrasive products or solvents.
▪ Clean the blades with an antibacterial spray. We recommend the STERIL CLEANER
920- cleaning, lubricating and disinfecting product.
22